Plantronics Cisco Certified Headsets

These are Cisco Unified Communications compatible Plantronics headsets (Plantronics H-series headset + Cisco cable) for Cisco 6900, 7800, 7900, 8800 series phones (6821, 6841, 6851, 6921, 6941, 6945, 6961, 7821, 7841, 7861, 7931G, 7940, 7940G, 7941, 7941G, 7942G, 7945, 7945G, 7960, 7960G, 7961, 7961G, 7962, 7965G, 7970, 7970G, 7971G, 7975G, 7985G, 8811, 8841, 8845, 8851, 8861, 8865). As well as Cisco 8900, and 9900 Series (8941, 8945, 8945G, 8961, 9951, 9971). See below for a selection of Plantronics Cisco IP phone compatible headsets (any Plantronics model below with a "-CIS", Cisco cable is included) will connect directly to your Cisco IP phone's headset port. These headsets comes the convenient Plantronics Quick Disconnect (QD) feature.

For Cisco 7811, 7902G, 7905G, 7906G, 7910G, 7911G, and 7912G, you will need the Plantronics H-Series headsets + Plantronics M22 amplifier. These phones do not have a headset port and requires the use of an amplifier.

For Cisco 7920, 7921, 7921G, 7925G, 7926G, 7929 cordless IP Phones. You will need Plantronics H-Series headsets + Plantronics Cisco 2.5mm cable

Looking for a Wireless Headset for your Cisco IP phone? Go to our Plantronics Wireless Headset page for the complete line. However, wireless headsets must be plugged in through your phone's receiver port, not your headset port. Also See our Cisco Headset Installation Guide for more information. Also see our Cisco direct connect headset page for complete list of other compatible Cisco Headsets

If you have a Cisco SPA303, SPA501G, SPA502G, SPA504G, SPA508G, SPA509G, SPA512G, SPA514G, SPA525G, SPA525G2. SPA921, SPA922, SPA941, SPA942, SPA962, Look HERE instead.

For Cisco CIPC, CUPC, Jabber softphone Compatible Headsets, Go HERE

Need remote answering for your wireless headset? If you have a Cisco IP phone 7942G, 7945G, 7962G, 7965G, 7975G, 8961, 9951, 9971, you can use EHS hook switch cable for remote answering. See below. Otherwise, you will need to use the HL10 lifter

Echo problem with your Cisco IP phone and wireless headset? Set the Handset/Headset monitor in Cisco Call Manager to Disabled. This will only route the call to the headset when the headset is used.